All Systems & Interiors news – Page 119
-
News
PICTURE: Mitsubishi Aircraft rolls out first MRJ
Mitsubishi Aircraft has rolled out its first flight test aircraft for the MRJ programme, in time good time ahead of its planned 2Q 2015 first flight.
-
Analysis
ANALYSIS: A330 rate cut shows challenge of bridging to A330neo
While Airbus has been overbooking its A320 line, ahead of starting its transition to the A320neo next year, it does not have the same flexibility to ease the path to A330neo production.
-
News
A350 secures ETOPS capability up to 370min
Airbus’s A350-900 will initially be approved for extended operations up to 370min.
-
News
First Qatar A350 carries out maiden flight
Qatar Airways’ first Airbus A350-900 has taken off from Toulouse, marking the maiden flight of a serial production A350 airframe.
-
News
Qatar narrows A350-900 delivery window
Qatar Airways is preparing to take delivery of the first Airbus A350-900 from 8-10 December, says chief executive Akbar Al Baker.
-
News
PICTURE: Rolls-Royce test-flies composite blade
Rolls-Royce has flown, for the first time, the composite blades to be used in its future UltraFan and Advance engine programmes.
-
News
First Qatar A350 prepares for maiden flight
Qatar Airways’ first Airbus A350 could make its maiden flight as early as today, following certification of the type at the end of September.
-
News
Sikorsky, Boeing finalise design of SB-1 Defiant
Sikorsky and Boeing have finalised the design of the team’s offering for the US Army’s joint multi-role technology demonstrator (JMR-TD), called the SB-1 Defiant.
-
News
Lockheed brings Infirno to surveillance market
Lockheed Martin has decided to enter the turreted surveillance payload market, unveiling the 15in (38.1cm)-diameter Infirno system for forward looking infrared and electro-optical imaging.
-
News
Boeing starts building parts for first 737 Max
Having delivered 8,224 737s of all variants from 1967 through September, Boeing’s workers are now starting to build the single-aisle's newest model launched in 2011 – the 737 Max.
-
News
Comac to take delivery of first C919 nose
The nose section for the first C919 prototype is expected to be delivered to Comac's final assembly centre on 15 October.
-
News
Airbus confirms intent to complete A330s in Tianjin
Airbus has confirmed tentative plans to establish an A330 completion centre in Tianjin, where the airframer already has an A320 final assembly line.
-
News
A350 MRO 'not a challenge' for Air France-KLM
Establishing MRO capabilities for the Airbus A350 appears to have been less taxing for Air France-KLM's maintenance division than the build-up of its support programme for the Boeing 787.
-
News
Maiden Leap-1C flight lasted nearly 3h
CFM International has confirmed the maiden test flight of its Leap engine family, beginning with a configuration to be used exclusively by the Leap-1C on the Comac C919.
-
News
CFM starts test flights with C919's Leap-1C: source
Test flights have commenced with the CFM International Leap-1C powerplant, according to a source familiar with the effort.
-
News
New data, refined analysis nudge MH370 search southwards
As the deep water search for the Malaysia Airlines Boeing 777-200ER missing since March commences, Australia has released an updated flight path analysis.
-
News
FL Technics to operate hangar at Soekarno-Hatta
FL Technics has won a tender to rent and operate an aircraft maintenance hangar at Indonesia’s Soekarno-Hatta International Airport.
-
Analysis
ANALYSIS: The ARJ21 progress report
Comac appears to be on the verge of finally getting its much delayed ARJ21 regional jet certificated, after having completed all the necessary ground tests and 95% of all flight test modules.
-
News
Swiss to revamp short-haul operations
Swiss International Air Lines is increasing seat numbers on its narrowbodies and launching several routes in an apparent offensive against Etihad Airways' local regional partner Darwin Airline.
-
News
Nacelle maker Aircelle opens Pont-Audemer facility
MRO provider Aircelle has opened a new facility in Pont-Audemer, France, giving the company capacity to develop nacelles for Airbus A320neos and A330neos.